[. . . ] (Remote Frequency Selection only functions on units configured for a remote Com Frequency recall switch. ) Setup ­ 1. Select "COM Configuration" on the Setup 1 Page, located in the AUX Page Group. [. . . ] On units configured for remote Com frequency recall, pressing the remote recall switch will load the next preset Com frequency into the unit's Standby frequency box and the unit will then display a temporary pop-up window with the current Preset number. The remote recall switch can be pressed multiple times to scroll the entire preset frequency list through the Standby frequency box (the list will "wrap" from the bottom of the list back up to the top, skipping any empty preset positions). The standby frequency isn't activated until a Com flip flop switch (either remote- or bezel-mounted) is pressed. © 2008 GARMIN Corporation GARMIN International, Inc. Liberty House, Bulls Copse Road, Hounsdown Business Park, Southhampton, SO40 9RB, U. K. +44 (0) 870 850 1243 Fax +44 (0) 238 052 4004 GARMIN Corporation No. 886/2. 2642. 9199 Fax 886/2. 2642. 9099 www. garmin. com 190-00356-32 Rev A 4 1 Approach Annunciation Table ­The annunciation description for LOW ALT has changed. Annunciation Description LOW ALT (lower window) For LNAV+V, LNAV/VNAV, or LPV approaches, the LOW ALT annunciation indicates the aircraft's estimated height is lower than the Final Approach Waypoint height by more than the current VPL plus 50 meters. If "WINDS" is not displayed, press the small right knob to highlight the displayed field and then turn the small right knob to change the field to "WINDS". To change the altitude for Winds Aloft: Turn the large right knob to move the cursor down to the Altitude field, then use the small right knob to select an altitude from ground level up to 42, 000 feet (in 3, 000-foot increments). TAWS - units equipped with TAWS have been enhanced with software v3. 00. These enhancements reduce the amount of TAWS nuisance alerts but do not change the operating characteristics to the pilot in any significant manner. The following Forward Looking Terrain Alerting Caution and Warnings should be adhered to when displayed: Cell Movement (CELL MOVE) shows the storm cells identified by the groundbased system. The tip of the arrow represents where the cell is expected to be in 10 minutes from the time the cell location was determined. To view XM Weather Cell Movement: while viewing the XM Weather page, verify "CELL MOVE" is displayed in the upper left corner. [. . . ] The following Forward Looking Terrain Alerting Caution and Warnings should be adhered to when displayed: Cell Movement (CELL MOVE) shows the storm cells identified by the groundbased system. The tip of the arrow represents where the cell is expected to be in 10 minutes from the time the cell location was determined. To view XM Weather Cell Movement: while viewing the XM Weather page, verify "CELL MOVE" is displayed in the upper left corner. [. . . ]